Engine House Module Benchwork

The benchwork is complete for the first module on my evolving City Point Terminal layout. Besides being the central focal point of the model railroad, this first module basically will be used to trial model railroad construction and modeling techniques. If the construction and modeling techniques work out well, they will be replicated on future modules, hopefully, without too much change. A model railroad always starts with the foundation, so here is a picture of the underside, as it stands today.

Railroad Bench Bottom

Railroad Bench Bottom

Basic underpinnings of this module follow an L-Girder design, very similar to what I did with my original model railroad. L-Girder design is described in the book “How to Build Model Railroad Benchwork“, by Linn H. Westcott. I have the second edition.

Changes from my original railroad benchwork

  • Is a much smaller size. This was done to allow the railroad to be built in pieces, moved and reassembled with minimum amount of problems. This module is 6′ 6″ long by a maximum of 4′ wide. Based on what I see today, I think that this is close to the largest size that still could be considered somewhat portable. It will have to be tipped vertically in order to move through normal doorways, but I hope that the finished module will be light enough that this can be done by a couple of people without too much difficulty.
  • The legs are bolted on to facilitate moving and storage. The bracing on the legs is done differently than what I did before. The end braces are connected where they cross with a dato joint and attached to only one side of the legs, rather than crossing on opposite sides of the leg. This construction should result in more stiffness, with slightly less weight. The other brace going down the side of the L-girder, is shorter than before. This length should provide plenty of stability but allow easier access to the underside of the layout.
  • The sides of the benchwork where it will eventually mate with adjacent modules are edged with pine boards. The open edges where the module does not mate with adjacent modules will eventually be covered with painted hardboard.
  • Next blog post will describe the top of the benchwork and roadbed.

    First City Point Model Railroad Module Benchwork

    This is the plan for the first module of my City Point Terminal Civil War model railroad. Additional modules will be added where each track leaves this module.

    Model Railroad Engine House Module

    Model Railroad Engine House Module

    At one point, I was going to model early December, 1864, as the 6th Army Corp returned from the Shenandoah Valley. However, I have decided that the late March, 1865 meeting between Lincoln, Grant, Sherman and Porter right after the battle for Fort Stedman would make a much more interesting moment in time. Besides major leaders, this moment also provides opportunities to depict masses of prisioners, and cavalry movements, as Sheridan’s cavalry passed near City Point upon his return from the valley during this time.

    The City Point terminal changed a lot over the period of Army occupation, and this is my best guess of the track layout at that point in time. This map has been edited in Photoshop to reflect differences between Merrick’s original map, which was made after the war and suriviving photos. There are two small buildings between the tracks on the right side of the diagram, that don’t show up on the map, that I will need to add. Also, there were two water tanks, one apparently was replaced by a small building before Merrick’s map was drawn.

    My next post will show the benchwork that I have already constructed for this module.

    Modern Views of the City Point and Army Line Yard Location

    Taken November, 2017, This View From the Bluff Views the Location of the City Point and Army Line Engine House

    Taken November, 2017, This view shows where part of the City Point and Army Line yard was located

    This picture was taken from the bluff, where the impressive row of barracks were located. The First Baptist Church of City Point is located there now. The bluff at the far side of the picture is where the railroad hospital was located. After taking this and several other pictures, a resident asked me if I was with the company that was planning some development there. I said no, I was interested in Civil War history. He said that was understandable. Maybe I should have asked him what was up, but felt that I didn’t want to disturb the residents any more than I already had done.

    Here is a famous view taken from the same general location during the Civil War.

    Water tanks and bluff where railroad hospital was located

    Water tanks and bluff where railroad hospital was located

    Here is a modern view of the cut leading to the yard.

    Cut leading to City Point Termnial

    Cut leading to City Point Termnial

    The US Military Railroad laid 3 parallel tracks in this cut.

    My overall impression is that there wasn’t a lot of extra space at City Point. Everything seems like it must have been squeezed pretty tightly together.

    Another Book about Lincoln at City Point and a Correction

    two Lincoln at City Point books

    two Lincoln at City Point books

    The book, “Abraham Lincoln At City Point” was written by national park historian, Donald C. Pfalz and published in 1989. My new book, “Lincoln’s Greatest Journey” was written by Noah Andre Trudeau and published in 2016.

    Both books contain a remarkably similar account of Lincoln’s stay at City Point in late March and early April of 1865. I would say that Pfalz’s book is a bit more scholarly in nature. Trudeau’s book is written more for general consumption and contains more background information about what was happening with the war in general and at the Petersburg front in particular.

    Despite the duplicate subject matter, for someone modeling City Point during this period in time, I can’t imagine not picking up both volumes. There aren’t really that many books that use so much ink describing what was going at at City Point, at the time.

    Now, for the correction. A while back, I made this post describing a theory I had about about Lincoln’s travel to the front on March 25th.

    Though I still think that Mr Pfanz was wrong in his assessment that the train took them to Patrick’s station, I was missing some information, and didn’t read the train reports closely enough.

    My assessment was also wrong. I should have investigated further, but it turns out that Meade’s HQ was near the Aikin’s house, which was near Parke’s station. Here is crop of Michler’s map of the Petersburg fortifications, showing the area from Meade’s HQ to Fort Wadsworth, the area that Lincoln’s party visited. I have labelled the area of Parke’s and Warren’s station, which are not noted on Michler’s original map.

    Lincoln's Visit to the Front

    Lincoln’s Visit to the Front

    It’s interesting that the train report that Bernard Kempkinski found in the National Archives doesn’t list a Parke Station at all. I suppose it was more of whistle stop, rather than a regular station. I now believe that Lincoln’s party probably left the train at Parke Station and went directly to Meade’s HQ, which would have have been proper protocol for a commander visiting his subordinates army. However, if Parke Station didn’t have the facilities to unload the horses that were brought along, the most logical first stop would have been Warren Station.

    Meade’s HQ area is where Lincoln’s party saw the prisoners from the fight for Fort Stedman. I finally realized why there would be prisoners so far from where the fighting took place, which was part of my confusion in the past. Meade’s army would have had provisions and procedures for handling prisoners. During the Civil War, the army’s provost guard HQ was usually near army HQ. Most likely, all prisoners the army captured, were sent to a holding area somewhere near the provost guard HQ for processing. This is why the prisoners from the fight at Stedman were marched to near the Aiken house.

    I don’t believe that Lincoln actually saw the battlefield around Stedman, itself. Since they were so far from the big fight at Stedman, I’m not really sure how many dead and wounded that Lincoln saw that day. However because of all the fighting going on across the front that day, it’s very likely that some wounded and perhaps a few men that had expired from their wounds were in the area that Lincoln visited.

    From Meade’s HQ, it would have been a fairly short ride by horseback to review part of the fifth corps and then on to Fort Wadsworth. There, the party could have obtained distant views of fighting going on in the area. From Fort Wadsworth, the group could easily have proceeded down the line to Patrick’s station, before returning to City Point on the train.

    I think that Trudeau’s book describes this trip to the front, pretty well, though I’m kind of skeptical about how many dead and wounded men were seen by the group.

    First Pass of a Mantua General Repaint

    First see this old old blog post about the remotoring and change to the drawbar that I did a few years ago.

    I am not a master modeler, but more recently, I’ve been working on changing an old Mantua General Locomotive over to the paint scheme of a US Military Railroad Norris type locomotive. With City Point being my main area of focus, I found some really good images of the Govener Nye, and decided to use that locomotive as my prototype.

    The original paint job was severely chipped and probably not very great to start with. I stripped the old paint off with lacquer thinner and then repainted. Here is the result.

    Generic USMRR Locomotive - paint based on Govenor Nye, a Norris built 4-4-0

    Generic USMRR Locomotive – paint based on Govenor Nye, a Norris built 4-4-0

    I used an ancient can of Humrol #96 RAF blue that was left over from my days as a wargamer for the Russian iron, and am very pleased with the result. Other paints were from what I had on hand. I’m not all that happy with the green, but it will do for now. Decals are from Microscale’s Eastern USMRR set.

    Besides the repaint here are some other things that I have done with this locomotive.

    I added a DCC decoder using a Digitrax DZ-123 Z scale decoder, which can handle the 1 AMP motor. At this time, I don’t plan on adding sound to my Civil War locomotives, thinking that an external sound system will be more impressive. For example, I’m contemplating having an actual whistle that will be controlled with the DCC throttle, just like any other locomotive with a built in sound system.

    I also added an engineer to the cab, but he is not very visable.

    After mucking around for a bit trying to make the Matua supplied wood pile look more realistic, I ended up replacing the wood in the tender. I scored the sides of some round toothpicks with a fine tooth metal cutting sabre saw blade. Then I stained them and then cut them to size using a end cutting pliers. After positioning them losely on the tender, I used diluted elmers glue to attach them to the top of the tender.

    What’s up next? I will add a line so the miniature engineer can ring the bell. I’m considering adding a working headlamp, but that may wait for a later date. I also need to program the speed tables for the DCC decoder. I will probably add a small magnet to the smoke/steam, so it can be removed when the locomotive is shut down, yet be a little more firmly attached when the locomotive is in motion.

    Retracing Abraham Lincoln’s Footsteps

    A month or so, ago, Bernie Kempkinski, made a post in the Yahoo, Civil War Railroad’s and Modeling group. This post had links to images of actual train reports from the City Point and Army Line Railroad during March and early April, 1865. Train reports list the times that trains passed the various stations on the line. Presumably the stations telegraphed trains movements back to City Point as they occurred. Bernie had found these reports in the National Archives.

    The dates of the reports that Bernie found, coincide with the final days of the siege of Petersburg and include March 25th, 1865, the day of the battle of Fort Steadman, and Abraham Lincoln’s visit to the front lines at Petersburg. Having a great interest in what was going during those days at City Point and Petersburg, I had previously purchased a book by Donald Pfanz, “Abraham Lincoln at City Point”. This books details Lincoln’s day by day activities during his time at City Point and vicinity during March and early April, 1865.

    Of course the first thing I had to do, was to see if the train Lincoln took to see the front on March 25th, was listed in the train report for that day. Pfanz’s book reports that the Lincoln party took a train at around noon. Sure enough, in the report there is a special train arriving at Pitkin Station, the next station up the line from City Point at 12:30 – that must have been Lincoln’s train.

    However this is where things get interesting. Pfanz writes that the Lincoln party went to Patrick Station, and then mounted horses and ambulances to visit Meade’s HQ. Pfanz writes that they arrived at Meades HQ around 1:00PM. He goes on to write that the party viewed a number of Confederate prisoners from the battle, then went to Fort Wadsworth to see the Sixth Corp take some advanced works in front of Boydon Plank Road.

    This story hardly could be the truth. Patrick Station is a mile beyond Warren Station, and Fort Wadsworth is between these two, and all are several miles down the track from Fort Stedman and Meade Station, which I presume was close to Meade’s HQ. The special train arrived at Warren Station at 2:00PM, long after Lincoln is said to have visited Meade’s HQ.

    I think it is more likely that the Lincoln party changed to ambulance and horse at Meade’s station, viewing the killed, wounded and prisoners from the battle of Fort Stedman near that location. Then they road down the line to Fort Wadsworth, from which they viewed the attack of the Sixth Corps. Afterward, they could have reboarded the train at Patrick Station for the return trip to City Point.

    regards,
    Mike Willegal

    “Stonewall” Jackson’s Raincoat

    “Stonewall” Jackson was shot by his own men while in the front lines doing some scouting while wearing this rain coat.

    How come I don’t remember anyone, pointing out that from a short distance or in the haze, smoke and confusion of battle that “Stonewall” Jackson’s Raincoat would look almost identical to a Union Officer’s Frock coat. Seems like a poor choice of clothing for the occasion.

    I’m just saying…

    Civil War Controversy: The Relieving of General Warren Before Five Forks

    A while back, I created a web page with some of my views on controversial topics of American Civil War history. The first topic talks about my view of the efficiency of Army of Potomac Corps commanders in both 1864 and 1865. One of the most controversial changes was on April 1, 1865, when General Phil Sheridan relieved General Warren of command of the V corps. To this day, the correctness of this decision is debated by civil war buffs.

    The website http://www.beyondthecrater.com has a number blog entries covering both sides of the controversy. What is especially interesting is reading the blog entry covering messages between various Union generals on May 30th and April 1st.

    My view is that Generals Grant, Meade and Sheridan had every right to relieve Warren. In my view, Grant didn’t trust Warren to do the right thing in a crisis. The messages captured in the Official Records clearly indicate that Generals Grant and Meade were attempting to micro-manage Warren’s actions. If Grant had confidence in Warren, I believe that he would have given Warren general directions to work with Sheridan in order to turn the Confederate left and cut the South Side Railroad. A commanders lack of confidence in a subordinate should be enough to justify removing a person from such an important role.

    Whether Warren was a competent corp commander or not, really is quite a different discussion. Even if he was actually the best corps commander in the world, if he didn’t have the confidence of his boss, relieving him of command, was the right thing to do. No commander should be saddled with a subordinate that he can’t trust in a crisis.

    Well Known Game Designer, John Hill, has Died

    It’s sad to see another icon of the wargaming world, has died. I found out today that well known game designer John Hill has died on January 12th, at age 71.

    I was deeply involved in wargaming in the mid to late 70’s and spent many hours playing his most well known game, “Squad Leader”. He also designed a popular Civil War Miniature’s rule’s set called “Johnny Reb”.